Wireless connection

• #0 Reply
  Posted by jfg69 on 30 Aug, 2010 17:12
• Some output from terminal
  
  

  Code: [Select]

  lspci -v | less:

04:09.0 Network controller: RaLink RT2600 802.11 MIMO
        Subsystem: Linksys Device 0057
        Flags: bus master, slow devsel, latency 32, IRQ 18
        Memory at fdcf8000 (32-bit, non-prefetchable) [size=32K]
        Capabilities: <access denied>
        Kernel driver in use: rt61pci
        Kernel modules: rt61pci

  

  Code: [Select]

  desktop:~$ sudo lshw -c network
  *-network               
       description: Wireless interface
       product: RT2600 802.11 MIMO
       vendor: RaLink
       physical id: 9
       bus info: pci@0000:04:09.0
       logical name: wlan0
       version: 00
       serial: 00:16:b6:55:d7:f2
       width: 32 bits
       clock: 33MHz
       capabilities: pm bus_master cap_list ethernet physical wireless
       configuration: broadcast=yes driver=rt61pci ip=192.168.1.141 latency=32 multicast=yes wireless=IEEE 802.11bg
       resources: irq:18 memory:fdcf8000-fdcfffff

  This was WHILE trying to connect unsuccessfully
  

  Code: [Select]

  ~$ iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wlan0     IEEE 802.11bg  ESSID:"XXXXX" 
          Mode:Managed  Frequency:2.462 GHz  Access Point: Not-Associated   
          Tx-Power=18 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:off

  Made a "new" wireless connection to my router, icon says "Connected 100%", but connection to internet not working.
  

  Code: [Select]

  :~$ iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wlan0     IEEE 802.11bg  ESSID:"XXXXX" 
          Mode:Ad-Hoc  Frequency:2.412 GHz  Cell: C6:4D:3C:86:B0:DB   
          Tx-Power=19 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:off

•